View Single Post
Old September 1, 2008, 12:14 PM   #1
Txhillbilly
Senior Member
 
Join Date: July 5, 2008
Posts: 288
Trouble with new AR lower

I built my first lower yesterday and put a new upper on. When I test fired the gun the 1st round fired fine,second round chambered but there was no trigger pull,like the trigger didn't reset.But when I extracted the second round I saw that the firing pin had contacted the primer on the second round and the round had not gone off. I thought there might be a problem with the new bolt assembly so I took my upper off my RRA AR and put on this new lower and same thing,first rd fires,second rd chambers but I have no trigger and the firing pin has contacted the second rd.
What did I do wrong,and how do I fix it?
Attached Images
File Type: jpg 2008_09010006.JPG (100.7 KB, 78 views)
File Type: jpg 2008_09010008.JPG (226.4 KB, 73 views)
Txhillbilly is offline  
 
Page generated in 0.05066 seconds with 8 queries