View Single Post
Old August 30, 2008, 12:35 PM   #5
davem
Senior Member
 
Join Date: October 4, 2004
Posts: 405
I'll check that, about the legs slipping off the cam. The way I set the timing, you have four clicks, the old C-O-L-T bit. In any event after the third click, when the cylinder locks, I only have to move the hammer back a fraction of an inch to catch, I was told that's the way it should be, otherwise you are stressing the parts. In any event maybe something is happening on the cam. I can cycle dry and all is well, I only have trouble after shooting a few rounds.
davem is offline  
 
Page generated in 0.04608 seconds with 7 queries