View Single Post
Old August 7, 2008, 09:11 PM   #3
Hawg Haggen
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 11,642
Sounds like it might be out of time. Cock the hammer fully and see if you can turn the cylinder to full lockup by hand. If it's already locked take a wooden dowel that just will fit down the bore and see if it enters the chambers. If not it needs work. FWIW, the CAS shooters over at SASS say the new Piettas are better than new Ubertis. Seems Ubertis QC has gone downhill in the last couple of years.
Hawg Haggen is offline  
 
Page generated in 0.04094 seconds with 7 queries