View Single Post
Old August 7, 2008, 11:33 AM   #10
BurkGlocker
Senior Member
 
Join Date: May 18, 2008
Location: Burkburnett, TX
Posts: 564
I found some high temp silicone washer type o-rings and it fit right over the gas valve, and when I put the gas tube on, it seals just perfectly. I figured it was at that point that it was the problem when it was just rattling around like a stone in a can. But it works perfectly now, and havent had a problem one with it since this 'fix'. but I will let y'all know how it works after I finish this case up...
__________________
Ammunition's no good if you don't have the guns and mags to load it up in...
BurkGlocker is offline  
 
Page generated in 0.05003 seconds with 7 queries