Thread: old 22 Sauer
View Single Post
Old July 28, 2008, 10:53 AM   #3
ocharry
Senior Member
 
Join Date: October 20, 2006
Posts: 221
thanks for the reply jim,,,what you are saying is exactly what i was thinking of doing,,,except i was going to use a end mill instead of a stub drill,,,there is a hole in the ratchet but i can't tell if it had a pin in it and it fell out or what it is for,,, and the print for the gun doesn't show this piece as a separate partor how it's put in

you are right too in it will have to be done in a milling machine and that is not a problem

anyone else???

ocharry
__________________
YHS
ocharry
ocharry is offline  
 
Page generated in 0.04763 seconds with 7 queries