View Single Post
Old July 17, 2008, 01:51 PM   #9
ELMOUSMC
Senior Member
 
Join Date: June 26, 2007
Location: N.E.IOWA
Posts: 362
Pahoo I had a similar problem with a CVA Hawken and it turned out that my method of cleaning was the problem.I used a bucket of hot soapy water and after removing the Nipple I used the tried and true pump and scrub to remove fouling after drying I replaced the nipple lubed the barrel and put the rifle away.After a time I noticed that I was getting hang fires.I removed the clean out screw and found that there was a moderate amount of carbon build up caused by lime from the boiling water used to dry the barrel ,the lubricant and the residue from the primers.This build up was causing the flame from the primer to defuse and cause the hangfires check your Bobcat it only takes a very small amout to cause a problem ELMOUSMC
__________________
USMC 1965-1992 For God,Country,Corps
ELMOUSMC is offline  
 
Page generated in 0.04102 seconds with 7 queries