View Single Post
Old July 17, 2008, 12:58 PM   #8
Pahoo
Senior Member
 
Join Date: February 16, 2006
Location: IOWA
Posts: 5,630
armedandsafe

Excellent Idea and I have experience with Process Control Orifice plates and that is exactly how these are machined, with the taper on the downstream side. I'm still going to replace the original nipple and take it from there. I understand that I am treating the effect and not the cause as this is the first sidelock that has given me this problem. Great imput!!

Be Safe !!!
Pahoo is offline  
 
Page generated in 0.04244 seconds with 7 queries