View Single Post
Old July 5, 2008, 12:39 PM   #8
WindLaker
Junior Member
 
Join Date: July 1, 2008
Location: Wiscomsin
Posts: 4
Did the freezer thing, same result. The soft part did not harden up hard enough to sand properly. I did sand the minute it came out of the freezer.

I tried the Dremel tool...very difficult to get a smooth, even finish. Since the freezer didn't work, I think I'm forced back to the Dremel.

I'm open to any other ideas.

Thanks,

WindLaker
WindLaker is offline  
 
Page generated in 0.04336 seconds with 7 queries