View Single Post
Old July 2, 2008, 12:13 AM   #2
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 11,408
Since the softer rubber moves when you try to cut it and the hard rubber backing plate actually cuts, this is entirely normal. Use packing tape to protect the stock of the gun (it is hard to cut and will show scuffs if you get too close with the sandpaper). Use 60 to 100 grit until the pad is cut down to the size you want it to be, then finish sand the backing plate with 150 grit to remove marks.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Taylor Machine
Scorch is offline  
 
Page generated in 0.03960 seconds with 7 queries