View Single Post
Old June 27, 2008, 12:18 AM   #4
mikerw
Junior Member
 
Join Date: June 26, 2008
Posts: 10
Thanks for the response guys.

There are two springs, the hammer spring and the receiver spring (not sure if that is the technical term, but the hammer spring (the larger spring) is in correct. I'm not sure how you can put either spring in incorrectly. They are just springs. I think the gun is put together correctly as it appears to operate as it did before I disassembled. I did not disassemble down past the hammer.

I'll give it another look over. There were no kinks in the springs when I investigated them. Receiver cover seems fine, the gun is babied and it just started happening. I do think it started happening after I started using some Blazer ammo though. Going to try some new ammo tomorrow and see if that does anything differently. I really think the action should be smoother though regardless of ammo.

Thanks again,

- Mike
mikerw is offline  
 
Page generated in 0.04904 seconds with 7 queries