View Single Post
Old May 20, 2008, 12:56 PM   #1
noelf2
Senior Member
 
Join Date: April 14, 2008
Location: Stafford, VA
Posts: 1,814
Pietta 1858 45 colt r&d conversion cylinder question

Looking into the cylinder chambers, it looks like each one is a tiny bit narrower at the barrel side, like it was bored a certain width up to the last quarter inch or so of the end of each chamber, then it is slightly narrower. Is this normal? I only noticed this the last time I cleaned it.
noelf2 is offline  
 
Page generated in 0.04417 seconds with 7 queries