Thread: 1872 Open top
View Single Post
Old May 13, 2008, 06:25 PM   #5
Hawg
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 11,719
Quote:
If you could not get the barrel off, how did you know that the cylinder pin was bent. The thing about some replicas is that the tolerances on the cylinder pin and barrel can be very tight. I had this situation on my .44 Army. It wasn't a bent cylinder pin, just a very tight gun.
If you'd read his post you'd know he sent it back to the factory to be fixed.
Hawg is offline  
 
Page generated in 0.04532 seconds with 7 queries