Thread: 1872 Open top
View Single Post
Old May 13, 2008, 10:53 AM   #3
tropicman
Junior Member
 
Join Date: May 12, 2008
Posts: 8
Gbro

Hello Gbro........I meant the barrel. The cylinder slides on the cylinder pin and then the barrel mounts on the end of the cylinder pin. The pin was bent at the factory so that the barrel couldn't be removed by hand. The installer at the factory must have had two left thumbs. I was using Titegroup smokeless powder starting loads.

Tropicman
tropicman is offline  
 
Page generated in 0.05500 seconds with 7 queries