View Single Post
Old March 6, 2008, 11:46 PM   #1
Doc Holdem
Junior Member
 
Join Date: March 6, 2008
Posts: 5
R&D Conversion, 3 cylinders wont fully cock

Hi all,

Just registered today, but been perusin the site for a couple weeks. I picked up an 1858 Remington clone (pietta) and ordered a conversion cylinder for it.

C&B cylinder works fine, but when I put the conversion cylinder in the revolver will only cock on 3 of 6 cylinders, feels like it is right at the edge on the others but won't go that extra bit to allow full cock.

If I am thinkin right, this means the hand is a hair too long right?

If so, would I need to file down the last notch on the hand?

any advice would be appreciated.

Thanks

Doc
Doc Holdem is offline  
 
Page generated in 0.05252 seconds with 7 queries