View Single Post
Old February 25, 2008, 06:55 AM   #2
mykeal
Senior Member
 
Join Date: October 8, 2006
Location: Northern Michigan
Posts: 2,725
Well, yes, I think there is.

I'm going to recommend a set of gunsmith's screwdrivers, although if this is the only screw you're having a problem with the solution is a bit expensive.

Brownell's, among others, sells gunsmith tools. Chapman's is a good quality set and it should contain the one you need. I would imagine you can find a smaller set for less money, but this one is a good assortment, so the odds of it having the bit you'll need are quite good.

http://www.brownells.com/aspx/NS/sto...EWDRIVER%20SET

Also, if you're not already doing so, consider using some thread anti-seize compound on the screw threads. I use Thompson Center's Bear Grease - there are lots of good alternatives.

Last edited by mykeal; February 25, 2008 at 06:56 AM. Reason: Add anti-seize comment
mykeal is offline  
 
Page generated in 0.04691 seconds with 7 queries