View Single Post
Old February 23, 2008, 09:47 PM   #6
Hawg
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 11,873
Try polishing the chambers. That will help close off pores in the metal. If you're getting rust on a patch but can't see it in the chambers it's probably down in tiny pits. Coating chambers with anything like paint will most likely make extraction difficult which I assume is why you were honing them in the first place.
Hawg is offline  
 
Page generated in 0.04118 seconds with 7 queries