View Single Post
Old February 11, 2008, 08:45 AM   #3
thallub
Senior Member
 
Join Date: November 20, 2007
Location: South Western OK
Posts: 2,125
The striker head should be nearly flush with rear end of the cocking piece. If the striker head is not flush with the rear of the cocking piece it is because the striker head is resting in the big deep notch of the bolt body. Turn the cocking piece until the striker head is in the small notch. The bolt will now enter the receiver.
thallub is offline  
 
Page generated in 0.04460 seconds with 7 queries