View Single Post
Old January 28, 2008, 06:27 PM   #4
Hawg Haggen
Senior Member
 
Join Date: September 8, 2007
Location: Mississippi
Posts: 11,434
The breech should have a wall thickness of at least the bore diameter which in your case would be about 1.75 inch. Drawn Over Mandrel (DOM) seamless steel is the usual choice. The breech plug should be threaded in place, no welding. The plug should extend at least the bore diameter into the bore and more is better.
Hawg Haggen is offline  
 
Page generated in 0.04587 seconds with 7 queries