View Single Post
Old October 18, 1998, 01:03 PM   #1
spark@onestopknifeshop.com
Wise Guy
 
Join Date: October 10, 1998
Posts: 665
Just a side note to what Zach just posted:

By far, the most common complaint recieved on the various boards I have run is that "My password isn't working!!!!"

Typically, the solution to this situation forms around one of two main user errors:

<ol>[*]Typing a Capital O instead of a zero (0). It's easy to confuse these two, which is why I recommend that when you get your password, you copy and paste it into the required box until you change it.</li>[*]Not copying the password exactly as it is shown. The UBB software is case sensitive when it comes to names and passwords. So when it runs it's checks, Spark is not the same as spark or SPARK. So, make sure that you type in your name and password exactly as it appears.

Like I said, by far these are the two most common problems I encounter, so good luck, and remember: attention to detail.

Spark
spark@onestopknifeshop.com is offline  
 
Page generated in 0.05496 seconds with 7 queries