View Single Post
Old April 3, 2007, 09:40 PM   #1
evan1293
Senior Member
 
Join Date: February 16, 2007
Location: CT
Posts: 784
How to Make Steel Plate Targets

Im looking to weld up some steel targets. Im looking for any suggestions on how to make some reactive steel targets. I've shot plates in matches before (there would be 5 plates in a line and each would fall... after that they could all be reset by pulling a cord)... any ideas on how to make this type of target? .... I haven't seen it for some time and can't remember how it was configured.

Also, I'ld like to make some pepper popper type targets and was looking for advice on how to make these. Should 1/4" steel suffice to stop handgun velocity bullets?

thanks
evan1293 is offline  
 
Page generated in 0.05437 seconds with 7 queries