View Single Post
Old March 25, 2007, 09:33 PM   #12
lgsracer
Member
 
Join Date: March 25, 2007
Location: Bayou La Batre AL
Posts: 54
If you are using a standard three die setup you can install this after the expander die:

Lee Rifle Charging Die

This die is used to charge small capacity rifle cases using the Auto-Disk Powder Measure. It works the same as the pistol powder through expanding dies except it doesn't expand the case mouth. Rifle case expansion is normally done in the sizing die.

http://www.leeprecision.com/cgi/cata...g/powhan1.html
lgsracer is offline  
 
Page generated in 0.05523 seconds with 7 queries