View Single Post
Old March 23, 2007, 12:09 PM   #2
Scorch
Senior Member
 
Join Date: February 13, 2006
Location: Washington state
Posts: 11,534
You will need a forming die and a neck reaming die to form 250 Savage out of 308 brass. This is because the sizing die does not generally push the shoulder back far enough to allow for rebound of the brass. RCBS used to sell complete forming die sets. You will also have a lot less case volume, so load carefully. It might just be easier to use 22-250 brass and run it into a sizing die to expand the neck.
__________________
Never try to educate someone who resists knowledge at all costs.
But what do I know?
Summit Arms Services
Taylor Machine
Scorch is offline  
 
Page generated in 0.05726 seconds with 7 queries