View Single Post
Old November 30, 2006, 12:01 AM   #186
HUBEL458
Senior Member
 
Join Date: March 8, 2000
Posts: 580
I have also found that the rear locking lug
idea will work with an Enfield, and it would
long enough for our long case with little
work. Work long case as singleshot.
Work as single stack repeater with 3" 12ga.
The bolt handle base would be one lug, and is quite large, which would be stronger than
goose guns built same way.The
left locking lug woud get a bite out on
its end if front was bored out to .900,
tp allow feeding of 12ga case.
But I found a way to add extra lug in the back by opening sight recess that is in rear bridge
down through to bolt raceway, mill groove on left for lug to turn into that
opening and mill square recess into bolt and add lug on left.Result 2.5 lugs, with enough
strength to hold 30k plus loads easily.
Ream out front of action. Barrel threads are
as big as Savage, little more than Mauser.
Face off front of bolt flat.Add pin in ejector
cutout to support case opposite extractor.
The original lugs will guide for feeding.
Screw in heavy 12ga rifled barrel.By the way
would work for 700NE,My 700HE by keeping
pressures moderate. Could handle 600Ne,
full pressure. Ed
__________________
ED HUBEL
HUBEL458 is offline  
 
Page generated in 0.04453 seconds with 7 queries