View Single Post
Old November 26, 2006, 11:32 PM   #185
HUBEL458
Senior Member
 
Join Date: March 8, 2000
Posts: 580
Some research. Anyone with a Mauser converted
to 12ga shotgun can fire our 4759 loads.
One was the GEHA, other REMO. The locking lug for bolt is the rear safety lug and if you wanted an extra lug do an Ed on the bolt
handle base to make contact between bolt handle and bolt handle recess.They are not long enough
for our full length case, but came with 2 3/4"
chamber and magazine.Were 2 shot large ring
converted military mausers.Studying this gun lead me to the idea that a fancy 12ga with 3" chamber could be made by the same thing that Germans did to the Mauser to make GEHA. Just use
a S&L, Colt Sauer, etc, with rear locking lugs.
Grind out inside diameter of action from rear reciever forward so 12ga case will feed, Rear of bolt will still center ok as lugs and metal
are there. The silver solder combination guide extension to support 12ga case on the left side
of bolt, and put extractor on right side.
Like a Sako or whatever.Face off the recess on front off bolt flat, Put in 12ga barrel with chamfers to clear extractor.A 788 Rem
may work, at least with a 2.75" case.
For repeater action, Open mag
well to hold a single stack of 1 or 2
12ga cases.Fancy gunwrighters badmouthed
the GEHA, but geese hunters just loved them,
as they handled heavy loads fine. Ed.
__________________
ED HUBEL
HUBEL458 is offline  
 
Page generated in 0.04610 seconds with 7 queries