View Single Post
Old August 10, 2006, 08:39 PM   #58
bobbg
Junior Member
 
Join Date: July 29, 2006
Posts: 13
190 bolt spring reinstallation

Hi Joons
The manual says that the spring can be installed using needle nose pliers and patience. I could not make it work no matter how I tried. The spring fits into a hole in the rear of the reciever housing that is open to the stock. I removed the stock and fed the spring in from the rear and while holding the spring in with a finger or screwdriver slip the stock back in place and install the nut that secures it. Sounds like a difficult feat but it is not. Good luck. You are going to like the rifle by the way.
Bob
bobbg is offline  
 
Page generated in 0.04286 seconds with 7 queries