View Single Post
Old July 6, 2006, 09:27 AM   #12
Senior Member
Join Date: April 25, 2005
Location: Arizona
Posts: 288
Scope Rings

Rich the rings I have are not smooth the are cut at about ten lines to the inch. What I did was to use a small amount of gold inletting compound spread on the lower half of the ring to see just how far out of round the rings where. Well like I stated they where surprising the hole I described is actually a dimple which is about an 1/8 inch deep.I don't know if the rings fit so well because of the way they are cut or just make so well. I have some Leupold rings on my sons flat top and those rings did need to be lapped. I guess it was just the luck of the draw. Be Safe Out There Kurt
Kurt Pietrzak
Maricopa Shooting Service
S.W.A.T. South West Airsoft Tactical
CCW Instrutor
NRA Certified Instructor
Maricopa ,Az.
rezmedic54 is offline   Reply With Quote
Page generated in 0.07519 seconds with 7 queries