Thread: OAL or Ogive
View Single Post
Old April 27, 2006, 09:51 PM   #1
flstfi
Member
 
Join Date: March 28, 2005
Location: California
Posts: 44
OAL or Ogive

Case= 6mm Remington
Projectile= Hornady 75gr hp

Using an O.A.L guage and a comparter I determined the maximum overall length to minimize freebore travel. I then deducted .030 from that figure. I then made up a dummy round and chambered it. It went in smooth and there were no marks on brass or copper to indicate any contact.

However the new length does not work well for the magazine in my model 700 Remington.

Is This Normal?????????
flstfi is offline  
 
Page generated in 0.04249 seconds with 7 queries