View Single Post
Old April 17, 2006, 01:09 PM   #10
DnPRK
Senior Member
 
Join Date: August 24, 2001
Location: LC, Ca
Posts: 1,771
If you go to the Ruger website and use Adobe to blow up the drawing to 300%, you'll see that part #5, the indicator, has a through hole and is trapped by the blind pin.

The good news is that Ruger will sell you a new indicator, pin and spring.

If you really need to get the indicator out, you could use a cutoff wheel and Dremel to grind away the indicator until it pops off he pin. Then grab the pin through the slot with a small pair of long nose pliers and back it out of the hole.
DnPRK is offline  
 
Page generated in 0.04450 seconds with 7 queries