View Single Post
Old April 15, 2006, 09:27 PM   #1
Overman
Senior Member
 
Join Date: April 9, 2005
Location: Colorado (not Denver or Boulder)
Posts: 186
How to remove a pin

I have a Ruger Mk III, and I want to (temporarily) remove the "loaded indicator" flag so I can touch it up with a Dremel.

It's held in place with a pin embedded in the barrel. You can't tap out the pin because you can only see the one end of the pin. It's a small pin, too.

I'm thinking about punching a dimple in the pin so a drill bit does not travel, take a very small drill bit, drill a hole in the pin, drive a screw into the pin, and pull it out.

Any advice appreciated.
Overman is offline  
 
Page generated in 0.04304 seconds with 7 queries