View Single Post
Old October 16, 2000, 07:13 PM   #1
HankL
Senior Member
 
Join Date: March 11, 1999
Location: The Sunny South
Posts: 2,174
I have reshaped a case here and there but have never run into this before. Going from .280 Rem to .280 Ackley Improved with new Remington brass. 30 cases to form with primer pockets reamed, flash holed deburred/
Sierra 150 gr Match HPBT seated to touch, Fed 210M primers and 54 gr. of H-4831. I shot 5 over the chrono with an avg. vel. of 2421 fps and a sd of 11. All cases had backed the primer a bit but were formed well.
I took the rest afield and plinked with them and after cleaning I noticed a crack on the outside of one case! With hand pressure I came up with this!

I have checked the rest of the cases with the pointed paper clip and no problems.
***?

[This message has been edited by HankL (edited October 16, 2000).]

[This message has been edited by HankL (edited October 16, 2000).]

[This message has been edited by HankL (edited October 16, 2000).]

[Edited by HankL on 05-27-2001 at 08:27 AM]
HankL is offline  
 
Page generated in 0.05393 seconds with 7 queries