View Single Post
Old February 13, 2006, 11:51 PM   #5
Leftoverdj
Senior Member
 
Join Date: October 15, 2004
Posts: 934
HSmith's reply is almost too good to follow. Only thing I have to add is that I would seat and crimp in separate steps for all the cartridges. Seat the whole batch first, and then crimp just as he suggested, but do not re-adjust the seating stem.

This adds an extra step but, without a crimp groove, the bullet will shave if it is pushed down while the crimp is applied.
Leftoverdj is offline  
 
Page generated in 0.04265 seconds with 7 queries