View Single Post
Old July 9, 2000, 11:19 AM   #2
swifter...
Senior Member
 
Join Date: March 16, 1999
Location: So. CA Mountains
Posts: 540
You really need to get a Sinclair Manual (& catalog!) for a really detailed explanation.
In passing, I'll say that outside turning is the best way. Inside reaming will follow the hole, so if one wall's thinner to start with, it will be thinner at the end. Outside turning will uniform the case necks. Don't try for a 100% clean-up, 60-75% works fine on factory chambers.
K&M )I think) has a new tool to remove the donut, but you can get it out by using a neck expander - moving the donut to the outside - and neck turning.
Hope this helped, but I really recommend reading some advanced reloading books to get all the data you need!

------------------
The Bill of Rights, and the Golden Rule are enough for civilized behavior. The rest is window dressing. Shoot carefully, swifter...

swifter... is offline  
 
Page generated in 0.04742 seconds with 7 queries