View Single Post
Old May 4, 2000, 09:34 PM   #9
Banzai
Senior Member
 
Join Date: January 29, 2000
Posts: 275
Just use caution. I've used a Lee undersized die for 40/10mm and found that with some brass, there can be difficulty in flaring the case to accept the bullet. Work up loads with one set of dies, and if you change sizing dies, work 'em up again, as neck tension (which is what really holds the bullet in, not the taper crimp) will be different, which will lead to pressure differences.

Tom


------------------
A "Miss" is the ultimate overpenetration!
You can never be too rich, too skinny, or too well armed!
Banzai is offline  
 
Page generated in 0.05171 seconds with 7 queries