Thread: brass
View Single Post
Old May 1, 2000, 05:37 PM   #1
Don Parsley
Member
 
Join Date: January 27, 2000
Posts: 17
I reload 40SW. After loading,some of the brass will not chanber in my case gage,while the others ran through the same resizer will.Has the case stretched or been reloaded too many times? It is always to big at the bottom.The loads i use are 5.0 WSL for a 140 grain FP, which is on bottom end or even starting load because of good performance.

[This message has been edited by Don Parsley (edited May 01, 2000).]
Don Parsley is offline  
 
Page generated in 0.04720 seconds with 7 queries