View Single Post
Old May 1, 2000, 02:50 AM   #7
Bill Adair
Senior Member
 
Join Date: April 18, 2000
Location: Seattle/Tacoma, WA USA
Posts: 345
<BLOCKQUOTE><font size="1" face="Verdana, Arial">quote:</font><HR>Originally posted by Kenneth L. Walters:
Attaching the strip primers every 25 rounds is no big deal....

Best progressive yet!
[/quote]

Ken,

Thanks for the info.

I've heard so much good and bad about the primer tube feed system, that I thought the strip feeder might be an improvement, or at least simpler to use?

Would it be feasable to package them in stip rolls of a thousand or more, and sell a simple roll feeder attachment you could bolt to the bench or press? Changing primer types would only require snipping the strip, or pulling it backwards out of the press, if that's possible.

Your right about finding primer strips being a problem. I've yet to see them on the shelf, though I'm told they cost no more than boxed primers.

Bill


[This message has been edited by Bill Adair (edited May 01, 2000).]
Bill Adair is offline  
 
Page generated in 0.05461 seconds with 7 queries