View Single Post
Old April 9, 2000, 09:07 AM   #1
k in AR
Senior Member
 
Join Date: October 12, 1999
Location: Arkansas USA
Posts: 434
Need help, I've been reloading for 30 years with std RCBS dies (lots of calibers too) with no problem, until I got my 357Sig dies!

Problem: bullets tend to move under recoil no matter how I crimp or size the neck.

Two possible solutions have come up:
1) pay for a custom "Lee Factory Crimp" die (if it is possible to make one for such a short cartridge)
2) roll a cannelure in the bullets (don't have a clue how to do this or what the equipment cost)

Anyone have any other ideas or a source for an inexpensive cannelure swager.
How about a 124gr JHP 9MM bullet that already has a cannelure in the right place so that the OAL wont exceed 1.140 ??

THank's k
k in AR is offline  
 
Page generated in 0.04242 seconds with 7 queries