View Single Post
Old March 14, 2000, 06:39 PM   #1
Gopher a 45
Senior Member
 
Join Date: January 24, 2000
Posts: 329
It's just an academic question but how are these two values derived? I was curious as to how you could use this info to reduce drag for bullets. Also, do you have to test the bullets to find out these values or can you figure them out mathematically before the bullet is even made. I know there's no substitute for actual testing, but can you get a ballpark figure so you can tell if you're on the right track design-wise?

John
Gopher a 45 is offline  
 
Page generated in 0.04429 seconds with 7 queries