View Single Post
Old January 1, 2006, 08:03 PM   #6
Bob - S.C.
Member
 
Join Date: March 13, 2005
Location: South Carolina
Posts: 19
One thing I would suggest that might cause that problem. Remove the bowl from the tumbler and check to insure that the threaded rods that hold the motor to the tumbler base are tight. They usually have four small nuts with lock washers. If they are not, that might be your problem. As previously mentioned, a loose lid can also cause a whole lot of racket.
Bob - S.C. is offline  
 
Page generated in 0.04306 seconds with 7 queries