View Single Post
Old January 19, 2000, 12:05 PM   #7
Bill Hebert
Senior Member
 
Join Date: May 15, 1999
Posts: 180
I use mine for loading everything. I also use the set and weigh method to set the proper charge. I turn the crank to fill the powder into the charge space and then I slightly tap the powder measure. I then turn the crank to dispense the powder into the case and then again tap the measure to assure all the powder is in the case. It sounds harder than it is but I get consistent and accurate powder charges with all types of powder.
Bill Hebert is offline  
 
Page generated in 0.04339 seconds with 7 queries