View Single Post
Old December 10, 1999, 03:49 PM   #5
Jack Straw
Senior Member
 
Join Date: July 26, 1999
Location: Georgia
Posts: 362
I looked back into my the Lee manual and found an article in there about calculating reduced loads. Has anyone tried Lee's formula? It seems rather complex, but if it works, it works. The only problem I can see with it (just from reading it, not trying it), would be the possibility of starting out with a charge of a powder that is below published minimums for that powder.

Thanks again,
Jack

[This message has been edited by Jack Straw (edited December 10, 1999).]
Jack Straw is offline  
 
Page generated in 0.03984 seconds with 7 queries