View Single Post
Old December 2, 1999, 11:18 PM   #1
TGS
Senior Member
 
Join Date: November 19, 1999
Location: Woodbury TN
Posts: 138
After 100 rounds of 300 gr and 260 gr factories (Hornady).
The brass was very tight in the chambers and when examined i have found them .006 - .008 out of square (O.D. to Rim). All the same and .0015 out of round. Ive noticed the cylinders have a tell tale out of round condition when viewing visually.
Is this condition dangerous, Im really reluctant to re-load this brass. Possibly the chamber diameters are not square to the cylinder face? Doesnt look like a condition I want to overlook or under estimate. The initial accuracy was pretty good. Under 1" at 33yds, but the emties shore look like there taking a toll first time thru. Whats going on?
TGS is offline  
 
Page generated in 0.04656 seconds with 7 queries