View Single Post
Old December 4, 1999, 03:00 AM   #1
jbyrd
Junior Member
 
Join Date: July 14, 1999
Posts: 9
I am reloading military brass and I have a question that I have to ask. I am using a primer pocket reamer by hand on once fired 223 military crimped brass. When I have finished the primer pocket appears to be a little off center but the primers seat nice and tight. I'm using 25 grains of IMR 4064 with a 55 grain FMJ BT.
What kind of problems could I encounter? Any major safety concerns? Is there a better way to remove the crimp?
Any comments would sure be appreciated.
jbyrd is offline  
 
Page generated in 0.04831 seconds with 7 queries