Thread: Getting started
View Single Post
Old November 11, 1999, 09:08 PM   #4
karlfitt
Member
 
Join Date: October 11, 1999
Location: Loveland,CO,USA
Posts: 34
One corner I feel you should not cut is on the dies themselves.
Dillon's are more expensive then every other out there but worth the money. If you load lead at all the dies need to be cleaned once in a while. With the dillon, you just pull a pin, clean the dies, and reassemble, all without changing the setting of the die.

Karl Fittinger
karlfitt is offline  
 
Page generated in 0.04666 seconds with 7 queries