View Single Post
Old October 17, 1999, 10:56 PM   #7
TheOtherMikey
Senior Member
 
Join Date: October 16, 1999
Location: Surprise, Arizona, USA
Posts: 171
Ditto again, I wouldn't load any auto pistol rounds without using a Lee taper crimp die.
For sizing, I insert a factory loaded round and tighten down the die until it is real snug, remove the round and give the die another quarter turn. I also check with my caliper. I haven't tried using a chambering guage as of yet.

Hope this helps, Mikey
TheOtherMikey is offline  
 
Page generated in 0.04243 seconds with 7 queries