View Single Post
Old December 7, 2005, 09:50 AM   #25
Remington kid
Senior Member
 
Join Date: September 15, 2005
Location: South Central West Virginia
Posts: 612
George, hat's just an inline capper and I've had it so long I can't remember who made this one. I took off the little spring useing a set of the small scre drivers you use for working on glasses. Then I used a file and sand papper to round off the edge and the end so it would fit over the nipple. Works good but my fingers are big and loading can be a pain in the butt. I still load with my fingers most of the time but I seat the cap all the way down useing a 3/8" doll rod with leather over the end. Never had one blow yet and I have done it that way for years.
Remington kid is offline  
 
Page generated in 0.04139 seconds with 7 queries