View Single Post
Old September 1, 1999, 04:16 PM   #3
swifter...
Senior Member
 
Join Date: March 16, 1999
Location: So. CA Mountains
Posts: 540
Actually, Merrill Martin and Roger Johnston were looking for ways to cut leading in cast bullet rifles when they developed the NECO system of moly coating.

I run cast bullets thru a Lee sizer, rinse in alcohol, dry, tumble in my shot/moly mix for 2&1/2 hours, wax for a minute or so, and then thru my old Lyman lubrisizer with their moly lube. The lube is softer than I like, but a dusting of Midway mica helps.
This has almost completely eliminated leading in my .41 magnum and .45 LC.



------------------
The Bill of Rights, and the Golden Rule are enough for civilized behavior. The rest is window dressing. Shoot carefully, swifter...

swifter... is offline  
 
Page generated in 0.04325 seconds with 7 queries