View Single Post
Old June 25, 1999, 10:51 AM   #10
Bill Hebert
Senior Member
 
Join Date: May 15, 1999
Posts: 180
Whenever I load LSWC's that are moly coated, debris collects in the die causing the bullets to seat deeper and deeper the more I reload. I have to remove the die and scrape out the lead and moly junk otherwise the bullets fall outside of the minimum overall length and the brass starts to buckle causing the problem you mention. I'm not suggesting that's your problem - only that it might be. watch the minimum OAL for the powder your loading - it varies from powder to powder. Good luck.
Bill Hebert is offline  
 
Page generated in 0.03690 seconds with 7 queries