View Single Post
Old October 31, 2005, 10:32 AM   #8
Doug.38PR
Junior member
 
Join Date: January 18, 2005
Posts: 3,298
Oh it did indeed need work.
Prior to the work, the forcing cone was so narrow that it was shaving the part of the metal strip of the .38+P round on the base of the bullet. Not only that, the cone was so unevenly cut all the way around that it would consistantly bind against the cylinder at a certain point.
Doug.38PR is offline  
 
Page generated in 0.04398 seconds with 7 queries