View Single Post
Old February 2, 2000, 07:13 PM   #3
BBBBill
Senior Member
 
Join Date: January 5, 2000
Location: Alabama
Posts: 197
On some guns, you can not polish enough to remove all tool marks from the feed ramp without removing too much metal. Just be happy with removing any ridges that grab your fingernail. Same with the throat of the barrel. If your gun is a fairly recent commercial Colt or similar, the throat will already be wide enough. It will just need polishing. After using a dowel with fine sandpaper, you can use a Dremel with a felt bob & polishing compound like "Blue Magic" for the final gloss.
BBBBill is offline  
 
Page generated in 0.04201 seconds with 7 queries