View Single Post
Old January 13, 2000, 08:21 AM   #3
ShooterDave
Member
 
Join Date: October 26, 1999
Posts: 39
Goerge: You've answered a question which I have been asking for quite a while, namely should I be suspicious of my Kimber's extractor which holds its cartridges quite a distance off the breach face? the tension checks out perfectly but I'll always get the occasional brass-in-face.

So, the issue is not (only) extractor tension, but extractor geometry?
ShooterDave is offline  
 
Page generated in 0.04303 seconds with 7 queries